Fuji Xerox DocuCentre-IV 2060, DocuCentre-IV 3060, DocuCentre-IV 3065 Administrator Guide

Copy Control

Copy Control

5 Tools
142
T
ools
5
Copy Control
You can configure settings related to copy operation control.
Memory Full Procedure
If there is insufficient hard disk memory while scanning a document, a screen appears asking 
you how you want to handle the partially stored data.
Set the process you want the machine to perform for the partially stored data after a certain 
time has elapsed in the confirmation screen.
You can set the time until the memory full procedure is carried out. For more information, refer to "Auto 
Job Release" (P.114).
Delete Job
Deletes the data partially stored.
Run Job
Treats the read-in data as valid, and start copying the document partially stored.
Maximum Stored Pages
Set the maximum number of pages stored for a copy document. You can set from 1 to 999 
pages.
Auto Paper Off
Select the tray used when [Auto Select] of [Paper Supply] in the [Copy] screen is cancelled. 
[Auto Select] of [Paper Supply] is cancelled when [Auto %], [Auto X-Y %] for [Independent X-
Y %], or [Slight Reduction (Improves Fit)] is selected.
Mixed Sized Originals - 2 Sided Copy
Specify paper to copy side 2 of a document: in 2 sided copying, if the size of side 1 and side 
2 of a document are different, and the machine detects different paper size for sides 1 and 2.
Important • When the side 1 and side 2 are different sizes and if the side 2 is copied on the sheet on 
which the side 1 has been printed, a part of the image may be missing.
Copy to new sheet
Side 2 is copied as side 1 on a new sheet of paper.
Copy to Side 2
Side 2 is copied on the reverse side of side 1 without changing paper size.
Fine-tune 100%
You can fine-tune magnification when copying at 100% (actual size). The set value is applied 
to [100%] in the [Copy] screen is set to 100%.
Set the value in the X/Y direction between 98 and 102% in 0.1% increments.
Important • This feature is applied only when a copy is made using the document glass. This setting is 
not reflected in the magnification (100%) under [Independent X-Y%] or [Calculator %].
Note
• A magnification displays [100%] even if [Fine-tune 100%] is selected.
ID Card Copy - Reduce/Enlarge
Set the copy magnification ratio when to copy ID cards. Selecting [Allow to Change] allows 
you to specify the ratio between 25 to 400 % in 1 % increments.
Note
• The machine may copy an ID card in a different orientation from the original orientation 
depending on the magnification ratio you specified.