Fuji Xerox DocuCentre-IV 2060, DocuCentre-IV 3060, DocuCentre-IV 3065 Administrator Guide

Changing the Paper Size for Tray 4 When Tandem Tray Module is Installed

Changing the Paper Size for Tray 4 When Tandem Tray Module is Installed

2 Paper and Other Media
48
P
a
pe
r a
nd O
the
r
 M
e
dia
2
Changing the Paper Size for Tray 4 (When Tandem Tray Module is Installed)
The following describes how to change paper size in Tray 4 when the Tandem Tray 
Module is installed.
1
Pull out Tray 4 until it stops.
Important • While the machine is processing a job, do 
not pull out the tray that is being used for 
the job.
• To prevent paper jams or erroneous 
detection of loaded paper in a tray by the 
machine, do not add paper on top of any 
remaining paper in the tray.
2
Remove any paper loaded in the tray.
3
Pinch the paper guide and slide it to the 
desired paper size.
4
Load and align the edge of the paper against 
the left edge of the tray, with the side to be 
copied or printed on facing down.
Important • Do not load paper above the maximum fill 
line. It may cause paper jams or machine 
malfunction.
5
While pinching the paper guide, lightly align 
the edge to the edge of the paper.
6
Push the tray in gently until it stops.
Note
• Affix the paper size label to the front of the paper tray.
7
Specify the type of loaded paper when you have changed the paper type.
For information on how to set the paper types, refer to "Changing the Paper Settings" (P.51).
CAUTION
Make sure to pull out the tray 
slowly. When the tray is being 
pulled out with force, the tray may 
possibly hit your knees or other 
parts of your body causing 
injuries.