HP Color LaserJet 4650 Software Reference Guide

If units are in millimeters, the custom media-size range minimum is the limit rounded up to the
nearest whole millimeter. The custom media-size range maximum is the limit rounded down to
the nearest whole millimeter. Any non-numerical entry reverts to the last valid entry. Width and
height entries are validated when the focus has changed.
The resolution of each control is one millimeter or one-tenth of an inch, depending on the current
measurement units. Clicking the up and down arrows increases or decreases the current value
by the increment amount (within the allowed range of values). The computer determines the rate
at which the values change.
Unit indicator labels change dynamically to indicate inches or millimeters, depending on the
measurement units the driver is currently using. To change measurement units, click the
dynamic Measurement Units button (either Use Inches or Use Metric).
Custom width and height control limits
The minimum media size for the HP Color LaserJet 4650 is 76.2 by 127 mm (3 by 5 inches)
and the maximum is 215.9 by 355.6 mm (8.5 by 14 inches). The following table summarizes
media size limits for each media-handling device.
Table 3-4. PCL 6 custom media sizes
Tray
Dimensions Minimum
Maximum
Tray 1 (multipurpose) Width
76.2 mm (3 inches)
215.9 mm (8.5 inches)
Height
127.0 mm (5 inches)
355.6 mm (14 inches)
Tray 2 (500-sheet)
Width
148.0 mm (5.83 inches)
215.9 mm (8.5 inches)
Height
210.0 mm (8.27 inches)
355.6 mm (14 inches)
Tray 3 (500-sheet)
Width
148.0 mm (5.83 inches)
215.9 mm (8.5 inches)
Height
210.0 mm (8.27 inches)
355.6 mm (14 inches)
Tray 4 (500-sheet)
Width
148.0 mm (5.83 inches)
215.9 mm (8.5 inches)
Height
210.0 mm (8.27 inches)
355.6 mm (14 inches)
Duplexing unit
Width
Custom sizes not
supported
Custom sizes not
supported
Height
Custom sizes not
supported
Custom sizes not
supported
Paper and envelope icons
The paper and envelope icons visually define width and height.
Dynamic measurement units 
Use the Dynamic Measurement Units button to toggle the unit of measurement between
standard (inches) and metric (millimeters) units of measurement. The label on this button is
dynamic, depending on the measurement units that are in use. If the custom size currently
shows the measurements in inches, the button is labeled Use Millimeters. If the custom
size currently shows the measurements in millimeters, the button is labeled Use Inches.
Click the button to switch measurement-unit types.
EN
Chapter 3 HP traditional print drivers for Windows
101